This handcrafted bed is minimalist in design, which would fit into any setting. The low panels create a bed that would complement any sized room, without being too dominant.
This bed has a clearance beneath the side rails of 15cm and the slats sit roughly 20cm off the ground. On a mattress with a thickness of 20cm, you would lie 40cm off the ground. This can be lowered or increased as you wish.
As with all our beds, there are no clips or brackets that support the side rails, which tend to bend over time. Instead, the side rails simply slot deep into the posts. As a result, it should be as strong in ten years time as on the day it is purchased!
We use solid wooden slats for the base, rather than thinner plywood sprung slats. The central reinforcing rail is independent of the slats, so can be positioned immediately below, to either give the slats no give whatsoever, or a tiny bit lower, to allow some flexibility in the base. This also means that over time, the slats won’t droop in the middle, as the middle rail will act as a constant buffer.
The wood can be left unfinished, stained, waxed or oiled.
The bed is the photo has been finished with a medium oak stain.
Please find the full specifications below. If you have specific requirements, feel free to get in touch.